Written by
Elena Marsh Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF096
ApplianceRange
Start a self-clean cycle with the door not registering as shut and the range answers with F096. Kenmore 790 freestanding ranges carry the entry, as do the Elite electric slide-ins 790.5256, 790.4131 and 790.4255.
1. The door itself
Make sure the door shuts completely and presses the switch plunger in. If it falls short, adjust the hinges; hinges with damage get replaced.
2. The door switch
With the range off power and the plunger held in, a technician tests the switch for continuity. A switch without continuity is replaced.
3. Wiring and board
A switch that tests good moves the check to the harness running from it to the relay control board: loose wires are reconnected, a damaged harness swapped. A harness in good order leaves the relay control board as the part to replace.
A Kenmore range in San Francisco that stops self-clean with F096 can be booked via (415) 825-6393. Tell us the model number and whether the door and hinges looked right. The Kenmore range repair page has an overview.
Model compatibility: Kenmore reuses codes across series and model years, so F096 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F096 means the oven door was detected open during a self-clean cycle.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Kenmore appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Kenmore appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
