VERIFIED
Two unrelated faults share F10, and the range decides which one you have.
Case 1: temperature running away
The meaning is an oven past 600 F and still going up. Listed for these ranges:
- 790-prefix self-cleaning electric, 2004 and newer
- self-cleaning electric, 2014 models
- Elite 790.4671 slide-in electric
- glass touch electric
- Elite slide-in gas or dual-fuel: 790.4261, 790.4260, 790.3264, 790.3263, 790.4276 and 790.4275
What the manual says:
- An oven that is not really overheating: check the temperature sensor probe, then power cycle the range.
- An oven that is overheating: disconnect power straight away.
- Overheating that repeats once power returns points at the electronic oven control board.
Heavy heat damage can end in replacing the entire range, according to the manual.
Case 2: upper oven door lock failure
The meaning on Elite 721-prefix electric ranges and Elite double-oven gas ranges with 721 numbers is that the upper door lock has failed.
- Unplug the range.
- Inspect the wiring from the upper lock motor to the relay control board.
- Inspect the wiring from the lock switches to the oven control board.
- Loose wires are reconnected and broken ones repaired.
- A technician measures the upper lock motor, expecting about 2,600 ohms. An infinite reading means the whole upper lock assembly is replaced.
Other Kenmore range codes
- f1 is the upper oven temperature sensor fault.
- f16 is a lower oven that is too hot.
- f15 is an oven control board failure.
Kenmore range repair in San Francisco
An oven that heats on its own should stay off. For Kenmore range repair in San Francisco and around the Bay Area, phone (415) 825-6393 and say whether the code was a lock problem or a temperature problem, plus the model number and what you tried.
Model compatibility: Kenmore reuses codes across series and model years, so F10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
