Written by
Elena Marsh Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF95
ApplianceRange
Ranges that list F95
Kenmore electric freestanding ranges with glass touch panel controls.
Kenmore Elite slide-in gas or dual-fuel units, models 790.4276, 790.4275, 790.4261, 790.4260, 790.3264 and 790.3263.
Both read F95 as a lock that failed. Within the glass touch chart, F90 through F95 form one group with a single remedy, and the Elite 790 chart adds the reset below.
Elite 790 slide-in: try this, then this
If the door seems stuck or refuses to latch, the range is left without power for 30 seconds and then restarted. Lockout or a clean cycle tests the latch, and cancel frees a door that stays closed. When the lock motor does not turn, power goes off again and the wires of the harness between lock assembly and oven control board are inspected; loose ones are seated and a damaged harness is replaced. If the wires check out, the lock assembly gets swapped, and only after that the relay control board, should the code stay.
Glass touch range: shorter route
Unplug it, inspect the harness running from the lock assembly to the electronic oven control board, replace the lock assembly if the wiring is good, and move on to the control board if F95 remains.
A Kenmore range in the Bay Area showing F95 is a job for Kenmore range repair; call (415) 825-6393. Have the model number and the outcome of the 30 second power reset at hand.
Model compatibility: Kenmore reuses codes across series and model years, so F95 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F95 means an oven door lock failure on Kenmore glass touch electric ranges and Elite 790 slide-in gas or dual-fuel ranges.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Kenmore appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Kenmore appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
